Walimex pro Wall Lamp Tripod 70-120cm

The sturdy arm of the walimex wall lamp tripod is adjustable in its inclination. In connection with the spigot, which is also adjustable, a versatile use of your studio flashguns is made possible.

• Download the full set of the instructions before setting up and using your device.
  
• Carefully read through the instructions before using the product for the first time. The instructions include all the important information that you will need to know about the product in order to avoid injuries and damage to your possessions and property.
  Risk of personal injury due to improper use.
  Loose parts that fall down may cause a fire or injuries. Parts on the device may fall down or may be loose and this can cause injuries, for example,
  when assembling studio flash lighting.
  
• Make sure that your tripod is always securely assembled.
  
• Always lay cables so that nobody can trip over them.
  
• Make sure that no one sits or leans on the tripod or the device.
  
• The tripod’s maximum load capacity must not be exceeded.
  
• Only mount your tripod onto walls with a suitable load-bearing capacity. The base plate is very flexible, and therefore it must be fastened to the wall using heavy-duty wall anchors with an appropriate load-bearing capacity.
  
• Be careful when adjusting the tripod that you do not injure your hands.
  
• Watch out for obstacles when extending or turning your tripod.
  
• Please note that moisture reduces the locks’ holding force. The centre column may start to slip under a heavy load. Therefore, if necessary, dry the parts on the centre column with a soft, absorbent cloth (e.g. made of cotton).
  
• Only adjust the centre column when the camera equipment has been securely fastened. Caution: This may damage your camera equipment and cause an injury.
  
• Make sure to check the lock that it is secure and tighten it with an appropriate tool (not included) if necessary. The centre column can only be removed by completely dismantling the catch. However, you do not need to fully loosen the screw for this.

• Walser GmbH
• Wilhelm-Lexis-Str. 8
• 52249 Eschweiler
• DE
• service@fotowalser.com