Walimex pro WAL-6702 Pro Tripod+WT-600 Trip Trolley

The walimex WAL-6702 Pro Tripod is made from extremely sturdy materials. It can be extended up to 156cm.
The rotating centre column is equipped with a 1/4-inch and 3/8-inch thread, so that heads and panheads can be attached. With the quick-release fasteners, you can adjust the tripod as you wish at any time. The foam rubber coating ensures a secure hold at all times.

The tripod is suitable for any surface. Use either the rubber feet for hard surfaces, the spikes for softer ground, e.g. grass , forest or in combination with the tripod dolly.

This is particularly suitable for studio photography thanks to its smooth-running wheels. Thanks to its sturdy construction, it can support heavy loads. This tripod dolly makes moving your tripod quick and easy. It can support up to 50 kg. You can lock your tripod in place by simply tightening the knurled screws on the tripod dolly.

• Download the full set of the instructions before setting up and using your device.
  
• Carefully read through the instructions before using your product for the first time. The instructions include all the important information that you will need to know about the product in order to avoid injuries and damage to your possessions and property.
  Risk of Injury Due to Improper Use
  
• Be careful not to trap your fingers in the struts on the tripod legs when folding your tripod.
  
• Please note that lamp tripods must be set up on a sufficiently strong, level surface to ensure maximum stability and load-bearing capacity.
  
• Carefully read through all the information regarding the tripod’s maximum load capacity.
  
• Please note that the specified load capacity applies to any equipment that is placed in the middle of the tripod. The specified maximum load capacity is not applicable when the centre column is fully extended. When the centre column is fully extended this results in a reduced maximum load capacity and the tripod may not be as stable.
  
• When adjusting the centre column with mounted equipment, for your own safety and to protect the installed equipment, make sure that you hold the centre column with one hand while loosening the locks before loosening the tripod locks.
  
  
• Moisture can damage the parts on the middle column, and this may reduce the holding force and the parts on the centre column can start to slope downwards under heavy loads. Therefore, if necessary, dry the parts on the centre column with a soft, absorbent cloth (e.g. made of cotton).
  
• Tripod weight bags should only be used to secure your tripod.
  
• Using tripod castors:
  Always lock the castors into place when you are not moving your tripod.
  
  Please Follow the Following Safety Information When Using a Ball Head or Pan Tilt Head:
  
• When your camera equipment is screwed on, hold your device with one hand whilst unlocking the ball head or pan tilt head to prevent any possible damage to your camera equipment.
  
• Make sure that the quick-release plate is inserted correctly and not tilted. The locking knob needs to be in the furthest locking position to prevent your camera equipment from falling down.
  Using a Crank (Depends on Model)
  
• When using a crank, the locking screw on the centre column must always be loosened before adjusting the height of the centre column, otherwise you could damage the delicate pitch thread.

• Walser GmbH
• Wilhelm-Lexis-Str. 8
• 52249 Eschweiler
• DE
• service@fotowalser.com