Walimex pro WAL-6702 pro tripod, 156cm

Walimex WAL-6702 Tripods – Ultra-stable and sturdy

Extremely sturdy, stable and durable

Working height from 37 to 156 cm (without tripod head)

Versatile thanks to the macro function

Features:

• Download the full set of the instructions before setting up and using your device.
  
• Carefully read through the instructions before using your product for the first time. The instructions include all the important information that you will need to know about the product in order to avoid injuries and damage to your possessions and property.
  Risk of Injury Due to Improper Use
  
• Be careful not to trap your fingers in the struts on the tripod legs when folding your tripod.
  
• Please note that lamp tripods must be set up on a sufficiently strong, level surface to ensure maximum stability and load-bearing capacity.
  
• Carefully read through all the information regarding the tripod’s maximum load capacity.
  
• Please note that the specified load capacity applies to any equipment that is placed in the middle of the tripod. The specified maximum load capacity is not applicable when the centre column is fully extended. When the centre column is fully extended this results in a reduced maximum load capacity and the tripod may not be as stable.
  
• When adjusting the centre column with mounted equipment, for your own safety and to protect the installed equipment, make sure that you hold the centre column with one hand while loosening the locks before loosening the tripod locks.
  
  
• Moisture can damage the parts on the middle column, and this may reduce the holding force and the parts on the centre column can start to slope downwards under heavy loads. Therefore, if necessary, dry the parts on the centre column with a soft, absorbent cloth (e.g. made of cotton).
  
• Tripod weight bags should only be used to secure your tripod.
  
• Using tripod castors:
  Always lock the castors into place when you are not moving your tripod.
  
  Please Follow the Following Safety Information When Using a Ball Head or Pan Tilt Head:
  
• When your camera equipment is screwed on, hold your device with one hand whilst unlocking the ball head or pan tilt head to prevent any possible damage to your camera equipment.
  
• Make sure that the quick-release plate is inserted correctly and not tilted. The locking knob needs to be in the furthest locking position to prevent your camera equipment from falling down.
  Using a Crank (Depends on Model)
  
• When using a crank, the locking screw on the centre column must always be loosened before adjusting the height of the centre column, otherwise you could damage the delicate pitch thread.

• Walser GmbH
• Wilhelm-Lexis-Str. 8
• 52249 Eschweiler
• DE
• service@fotowalser.com